Kenmore Ultra Stitch 12 Bobbin

  1. Kenmore Sewing Machine 12 Stitch
  2. Kenmore Ultra Stitch 12 Parts
  • Load your Kenmore sewing machine with the right thread and bobbin thread for your project.
  • Kenmore Ultra Stitch 12 Bobbin Holder The front of your machine should be marked with an 'A' path and 'B' path, or with equivalent labels. Draw the thread down the A path, hooking it into the latch at the bottom of the path, and back up through the B path at the left.

Kenmore Sewing Machine 12 Stitch

Ultra

Kenmore 272.98100.491 Sewing machine cabinet Owner's Manual (12 pages) Sewing machine cabinet. Kenmore 18221 - Drop-In Bobbin Sewing Machine Owner's Manual (111 pages) Owners manual. Table Of Contents.

Kenmore Ultra Stitch 12 Parts

My drive wheel on my Kenmore ultra 12 stitch has jammed. I can not turn the wheel anymore than a quarter or a turn. What would cause this to happen? How do I fix it so the sewing machine will sew again?



Rhonda from Manhattan, KS

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

July 21, 20070 found this helpful

My Kenmore is over 30 years old and I have no idea what model it is, but it used to jam all the time and it was in the bobbin housing. Can't tell you how many times I've had to take that thing apart in the middle of a project. It seems to be very sensitive until you get the bobbin adjusted to the type of fabric and thread you're using. I eventually learned to practice on a scrap piece of the fabric first. This may or may not be the problem you're describing, but hope it helps.

July 25, 20070 found this helpful

Do you have an owner's manual? Check it out! There is usually a diagram with all the parts labelled. Many machines especially older ones, are belt driven.

Kenmore ultra stitch 12 manual

The belt could be stretched or worn. Have u tried contacting Kenmore(Sears) service department by email or check for a website.
July 25, 20070 found this helpful

Thank You for your help
I have taken the machine apart and have finally determined that I will have to take it to Sears for repair. I almost took the entire machine apart to check each component and still did not get the wheel to turn....I am baffled
Once again thanks

July 25, 20070 found this helpful

There is probably something jammed in the bobbin case . Take it apart and clean out the lint, loose threads and broken needle pieces, etc.


Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!